Kia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the Solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
(Refer to Underdrive Brake Control Solenoid Valve - "Specifications")
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
See also:
Removal
1.
Separate the push rod (C) after remove the pin (A) and washer
(B).
2.
Remove the battery.
(Refer to Engine Electrical S ...
Sunroof Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly (A) after loosening
2 screws.
...
Battery Vehicle parasitic current inspection
1.
Turn the all electric devices OFF, and then turn the ignition
switch OFF.
2.
Close all doors except the engine hood, and then lock all d ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026