Kia Forte: TJ Joint Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Inspection
| 1. |
Check the spider assembly for roller rotation, wear or corrosion.
|
| 2. |
Check the groove inside the joint case for wear or corrosion
|
| 3. |
Check the TJ boots for damage and deterioration.
|
TJ Joint Replacement
•
Special grease must be applied to the driveshaft joint.
Do not substitute with another ...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline (TJ) to prevent damage
to the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
See also:
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Control Shaft Complete Installation
1.
Install in the reverse order of removal.
•
...
Power Door Lock Switch Inspection
Driver Door Lock Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front ...
Copyright © www.kifomanual.com 2014-2025