Kia Forte: Hub nut tightening sequence

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / maincat / Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:

88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

2.

Measure the wheel Run-out by using a dial indicator as illustration below.

Run-out	Aluminum	Steel
Radial mm(in.)	Below 0.3(0.0118)	Below 1.4(0.0551)
Lateral mm(in.)	Below 0.3(0.0118)	Below 0.9(0.0354)

3.	If measured value exceeds the standard value, replace the wheel.

maincat

...

Tire Pressure Monitoring System

...

See also:

Components Location
1. Purge Control Solenoid Valve (PCSV) 2. Vapor line 3. ORVR valve 4. Fuel tank air filter 5. Canister Close Valve (CCV) 6. Canister 7. Fuel Tank Pressure Sensor ( ...

Fuel Tank Installation
1. Install in the reverse order of removal. Fuel tank band installation nut: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...

IMS Power Seat Control Inspection
1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity ex ...

Categories

Copyright © www.kifomanual.com 2014-2026