Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module / Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.

Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.

Tightening torque :

5.5 ~ 6.5 N.m (0.56 ~ 0.66 kgf.m, 4.1 ~ 4.8 lb-ft)

4.	Install the crash pad. (Refer to Body - "Main crash pad assembly")

Tighten the passenger airbag mounting bolts.

Tightening torque :

8.0 ~ 9.0 N.m (0.82 ~ 0.92 kgf.m, 5.9 ~ 6.7 lb-ft)

6.	Connect the passenger airbag harness connector to the SRS main harness connector.

7.	Reinstall the glove box housing. (Refer to Body - "Glove box housing")

8.	Reconnect the battery negative cable.

After installing the passenger airbag (PAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal

1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the glove box housing. ...

Side Airbag (SAB) Module

The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Si ...

Kia Forte: Installation

Removal

Side Airbag (SAB) Module

See also:

Categories