Kia Optima Manuals

Kia Forte: Installation - Emergency Fastening Device (EFD) - Seat Belt Pretensioner - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) / Installation

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least thirty seconds.
3.
Install the emergency fastening device with a bolt (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the emergency fastening device connector (A).
5.
Install the center pillar trim.
(Refer to Body - "Center pillar trim")
6.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
7.
Insert the seat belt to the emergency fastening device.
  
Make sure the lock pin is connected in properly.
8.
Reconnect the battery negative cable.
9.
After installing the emergency fastening device, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Brake System
...

See also:

SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12)  Internal resistance(Ω ...

Thermostat Components
1. Water inlet fitting 2. Thermostat 3. Bypass hose 4. Heater pipe & hose assembly ...

Description
Burglar Alarm State [B/A State] B/A State Description DISARM 1. In "DISARM" state, no vehicle start inhibition. So, whe ...

Categories

Copyright www.kifomanual.com 2014-2026