Kia Forte: Hood Latch Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Replacement

1.	Disconnect the hood latch connector (A).

2.

Remove the hood latch assembly (A) mounting bolts.

Tightening torque :

7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

3.	Disconnect the hood latch release handle cable (B) and remove the hood latch assembly (A).

4.

Install in the reverse order of removal.

•	Make sure the hood latch release cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

•	Adjust the latch alignment.

Hood Latch Component Location

1. Hood latch assembly ...

Trunk Lid

...

See also:

Fuel Tank Pressure Sensor (FTPS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Pull the passenger seat towards the front till the end. ...

Injector Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Categories

Copyright © www.kifomanual.com 2014-2025