1. |
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
|
2. |
Remove the front oil seal (A).
|
3. |
Apply engine oil on the edge of new oil seal.
|
4. |
Using the SST (09231-2E000), install a front oil seal (A).
|
5. |
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
|
TJ Joint Installation
1.
Wrap tape around the driveshaft spline (TJ) to prevent damage
to the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Rolling code programming
To train a garage door opener (or other rolling code equipped devices) with the
rolling code feature, follow these instructions after completing the "Programming"
portion of this text. (A ...
Ignition Coil Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...