Kia Forte: Fuel Pump Motor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Motor Removal
| 1. |
Remove the fuel pump (Refer to “Fuel Pump” in this group).
|
| 2. |
Disconnect the electric pump wiring connector (A) and the fuel
sender connector (B).
|
| 3. |
Remove the head assembly (A) after releasing the cushion fixing
clip (B).
|
| 4. |
Disconnect the fuel tube quick-connectors (C).
|
| 5. |
Remove the fuel sender (A) in the direction of an arrow.
|
| 6. |
Disconnect the fuel tube connector (A).
|
| 7. |
Remove the cut valve (A) after releasing hooks (B).
|
| 8. |
Remove the reservior-cup (B) after releasing the fixing hooks
(A).
|
| 9. |
Release the fixing hooks, and then remove the pre-filter (A).
|
| 10. |
Remove the electric motor pump motor (B) from the fuel filter
(C) by pulling it in down direction.
|
Fuel Filter Installation
1.
Install in the reverse order of removal.
...
Fuel Pump Motor Installation
1.
Install in the reverse order of removal.
...
See also:
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies greatly upward or downward
&qu ...
PTC Heater Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel" ...
Rear Seat Belt Buckle Replacement
(4Door)
[LH]
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Loosen ...
Copyright © www.kifomanual.com 2014-2025