Kia Forte: Intake Air Temperature Sensor (IATS) Description

Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature.

To calculate precise air quantity, correction of the air temperature is needed because air density varies according to the temperature. So the ECM uses not only MAPS signal but also IATS signal. This sensor has a Negative Temperature Coefficient (NTC) Thermister and it's resistance changes in reverse proportion to the temperature.

Manifold Absolute Pressure Sensor (MAPS) Installation

   • Install the component with the specified torques. • ...

Intake Air Temperature Sensor (IATS) Specification

Temperature [°C(°F)] Resistance (kΩ) -40(-40) 40.93 ~ 48.35 -20(-4) 13.89 ~ 16.03 0(32) 5.38 ~ 6.09 10(50 ...

See also:

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

Purge Control Solenoid Valve (PCSV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A) ...

Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent with antifreeze characterist ...