Kia Forte: Manifold Absolute Pressure Sensor (MAPS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage when installation.
|
|
|
1. |
Install in the reverse order of removal.
Manifold absolute pressure sensor
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute
Pressure Sensor and detects the intake air temperature.
To calculate precise air quantity, correction of the air tem ...
See also:
Rear Oil Seal Components
1. Rear oil seal
...
General Information
1.
Check & Change intervals
Check & Replenishment
Change
Capacity
Oil specification
...
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector in driver
side crash pad lower panel, turn the power on GDS.
...
Manifold Absolute Pressure Sensor (MAPS) Removal
Intake Air Temperature Sensor (IATS) Description