Kia Forte: Operation
|
1. |
General Function
| A. |
Auto-learn takes place only once per Ignition cycle.
|
| B. |
On successful completion, 4 road wheel sensor ID's are
latched into memory for monitoring.
|
| C. |
Until Auto-learn completes, previously learned sensors
are monitored for under inflation / leak warnings.
|
|
|
2. |
General Conditions to Learn New Sensors:
| A. |
Receiver must determine that it is confident that sensor
is not temporary:
|
| 2) |
Uses confidence reduction of previously learned
sensors.
|
|
| B. |
Typical time at driving continuously over 15.5 mph(25
kph) to learn a new sensor is up to 20 minutes.
|
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
| A. |
It takes less than 20 minutes at 15.5 mph(25 mph).
|
| B. |
Confidence reduction is dependent on time which vehicle
is driven at speed greater than or equal to 12.4 mph(20 kph).
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
Oil Pump Unit (OPU) Inspection
OPU Problem Inspection Procedure
1.
TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis
ground using the backside of OPU harness connector ...
Removal
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray ...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross V ...
TPMS Receiver
Replacement