The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
2. |
Disconnect the connector (A) of parking brake switch.
|
3. |
Remove the parking brake cable (B) after removing the cable retainer
(A).
|
4. |
Remove the parking brake lever assembly (A) after removing the
bolts.
|
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Seat Heater (Air Ventilation) Inspection
Front Seat Heater (Driver)
1.
Check for continuity and measure the resistance between terminals.
No.
Description
No.
...
Rear Hub - Carrier Components
1. Rear torsion beam axle assembly
2. Rear dust cover
3. Rear wheel hub assembly
4. Rear brake disc
...