Kia Forte: Power Seat Control Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Seat Electrical / Power Seat Control Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the seat side cover (A).
|
| 3. |
Disconnect the power seat control switch connector (A).
|
| 4. |
Remove the power seat control switch (A) after loosening the mounting
screw.
|
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Power Seat Control Switch Installation
1.
Connect the connector and install the power seat control switch.
2.
Install the seat cover.
...
See also:
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs ar ...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...
Rear Door Module Component Location
(4Door, 5Door)
1. Rear door module
...
Copyright © www.kifomanual.com 2014-2025