Kia Forte: Removal - Vehicle Speed Sensor - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Vehicle Speed Sensor / Removal

1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the vehicle speed sensor (A).

4.
Remove the vehicle speed sensor (A) and driven gear.

Tightening torque:
4.9 ~ 6.9 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.1 lb.ft)

  
After removing speed sensor, be careful not to enter dust, foreign matters, etc in speed sensor hole.
5.
Separate the vehicle speed sensor (A) and driven gear (B).

Inspection
W/Harness Inspection 1. Check the vehicle speed sensor by using the scan tool. (if normal, current vehicle speed is display) 2. Chec ...

Installation
1. Install in the reverse order of removal.    Do not reuse the O-ring (A). ...

See also:

IMS Control Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the seat side cover (A). 3. Disconnect the p ...

Multimedia Jack Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly&quo ...

Windshield washers (front)
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wip ...

Copyright www.kifomanual.com 2014-2026