Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the battery (A) and ECM (B).
|
| 3. |
Remove the master cylinder.
(Refer to Master Cylinder)
|
| 4. |
Remove the snap pin (A) and clevis pin (B).
|
| 5. |
Remove the mounting nuts (A).
|
| 6. |
Disconnect the vacuum hose (A) from the brake booster.
|
| 7. |
Remove the brake booster (B).
|
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Inspection
1.
Inspect the check valve in the vacuum hose.
Do not remove the check va ...
See also:
Description
Idle Stop & Go (ISG) function automatically switches off the engine when
the car is at a standstill if the and starts it again as soon as the brake pedal
is released. This not only reduce ...
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
Rear Seat Assembly Replacement
[Rear seat cushion assembly]
1.
Disconnect the rear seat cushion heater connector (A) from the
trunk inner side.
2.
After loosening th ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026