Kia Forte: Shift Lever Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Shift Lever Removal
| 1. |
Remove the floor Interior console assembly.
(Refer to Body - " Floor Console")
|
| 2. |
Remove the cover (A).
|
| 3. |
Remove the select cable (B) by removing the snap pin (A).
|
| 4. |
Remove the shift cable (B) after removing the clip (A).
|
| 5. |
Remove the cable socket (A) from lever assembly after pulling
the cable socket clip in the direction of the arrow.
|
| 6. |
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
|
| 7. |
Remove the boots (A) and knob (B) from the lever assembly.
|
Shift Lever Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Shift Lever Installation
1.
Install in the reverse order of removal.
•
...
See also:
Components
1. Control shaft complete
2. Back-up lamp switch
3. Vehicle speed sensor
4. Transaxle housing
5. Transaxle case
...
Crankshaft Position Sensor (CKPS) Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel") ...
Copyright © www.kifomanual.com 2014-2025