Kia Forte: Starter Installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Starter Installation

1.
Install in the reverse of removal.
Starter Removal
1. Disconnect the battery negative (-) cable. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &qu ...

Electric Oil Pump Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the input shaft to generates oil pressure when input shaft rotates. But, this transaxle equipped with ISG system also has ...

See also:

Fluid Components Location
1. Injection hole(eyebolt) 2. Oil level plug 3. Oil drain plug ...

Rear Oil Seal Installation
1. Install a new rear oil seal. (1) Apply engine oil on the edge of new oil seal. (2) ...

Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

Copyright www.kifomanual.com 2014-2026