1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the VIS valve connector.
|
3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Battery replacement
A battery should last for several years, but if the transmitter or smart key
is not working properly, try replacing the battery with a new one. If you are unsure
how to use or replace the batter ...
Cylinder Head Cover Installation
1.
Install cylinder head cover.
(1)
The hardening sealant located on the cylinder head cover
and the gap between the timing chain co ...