Kia Forte: Auto Defogging Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the glove box housing.
(Refer to Body -"Glove Box Housing")
|
| 3. |
Remove the passenger's side shower duct by loosening the screw.
|
| 4. |
Disconnect the connector (A) and then remove the auto defogging
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Auto Defogging Actuator Inspection
PTC Heater DescriptionTorque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54)
Current value(mA)
...
Component Location
1. Hood switch
2. Burglar horn
3. BCM and RF antenna
4. Key warning switch
5. Front door switch
6. Front door lock actuator & switch
7. Rear door lock actuator &am ...
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cov ...