Kia Forte: Control Shaft Complete Installation - Manual Transaxle Control System - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Control Shaft Complete Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete Installation

1.
Install in the reverse order of removal.
  
•
When installing, set control shaft lever to neutral position.

•
When installing, apply the sealant as shown in the illustration.

Specified sealant : MS 721-40 or MS721-38

2.
After installing, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of shift lever.
Control Shaft Complete Removal
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

Automatic Transaxle System
...

See also:

Shift Lever Removal
1. Remove the floor console assembly. (Refer to Body - "Floor Console") 2. Remove the air duct. 3. ...

ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function Connector [CNG-MA] Pin No. Description Connected to 1 Ignition Coil (Cylinder #1) control output Ignition Co ...

Canister Close Valve (CCV) Circuit Diagram
(M/T) (A/T) ...

Copyright � www.kifomanual.com 2014-2026