Kia Forte: Cooling Fan Disassembly

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Disassembly

1.	Remove the cooling fan (A) from the cooling fan assembly.

2.	Disconnect the fan motor connector (A) from the resistor.

3.

Loosen the screws and then remove the fan motor (A) from the cooling fan shroud.

Tightening torque:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.	Assemble in the reverse order of disassembly.

Cooling Fan Removal and Installation

Cooling fan assembly 1. Disconnect the battery "-" terminal. 2. Remove the air duct and air cleaner assembly. (Refer to ...

Cooling Fan Inspection

Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...

See also:

Alternator Installation
1. Install in the reverse order of removal. 2. Adjust the alternator belt tension after installation. (Refer to Engine Mechanical ...

License Lamp Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the lens (A) after loosening the mounting screws. 3. ...

In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

Categories

Copyright © www.kifomanual.com 2014-2026