Kia Optima Manuals

Kia Forte: Cylinder Head Disassembly - Cylinder Head Assembly - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Cylinder Head Disassembly

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Disassembly

  
Identify, valves and valve springs as they are removed so that each item can be reinstalled in its original position.
1.
Remove the valves.
(1)
Using the SST (09222-3K000, 09222-3K100), compress the valve spring and remove the retainer lock (A).
  
When installing the SST, insert the front support (A) directly into the bolt hole on the cylinder head.

  
Do not press valve retainer more than 12 mm (0.47 in.).
(2)
Remove the spring retainer (B).
(3)
Remove the valve spring (C).
(4)
Remove the valve (D).
(5)
Using needle-nose pliers, remove the valve stem seal (E).

  
Do not reuse the valve stem seals.
Cylinder Head Removal
Engine removal is not required for this procedure.    • Use fender covers to avoid damaging ...

Cylinder Head Inspection
Cylinder Head 1. Inspect for flatness. Using a precision straight edge and feeler gauge, measure the contacting surface of the cylinder block and the ma ...

See also:

Component Location
1. Driver power window main switch 2. Passenger power window switch 3. Front window motor 4. Rear window motor 5. Rear window switch ...

Front Wiper Motor Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 2. Attach the positive (+) lead from the battery to terminal ...

Starter Disassembly (NON-ISG Type)
1. Disconnect the M-terminal (A) on the magnet switch assembly. 2. After loosening the screws (A), detach the magnet switch ssembly ...

Categories

Copyright www.kifomanual.com 2014-2026