Kia Forte: Engine Control Module (ECM) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Removal
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the ECM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery. (Refer to Engine Electrical System - "Battery")
|
| 4. |
Remove the mounting bolts (A) and then remove the ECM (B).
|
Engine Control Module (ECM) Circuit Diagram
(M/T)
(A/T)
...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
See also:
Installation
1.
Install in the reverse order of removal.
2.
After installation, bleed the brake system.
(Refer to Brake system bleeding)
...
Replacement
1.
Remove the cap (A) and remove the nuts, then remove the wiper
arm (B).
Tightening torque :
22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 ...
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between NO.1 and NO.2 terminals.
2.
Inspect the voltage v ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026