Kia Forte: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
|
| 3. |
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
|
| 4. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
|
| 5. |
Disconnect the light switch connector (A) and the wiper switch
connector (B).
|
| 6. |
[RHD]Remove the wiper switch (A) by pushing the lock pin (B).
|
| 7. |
Loosen the screws (2EA) from the multifunction switch assembly
(A).
|
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
Installation
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lowe ...
See also:
Output Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.1 ~ 1.55)
0.043 ~ 0.061
Output voltage
...
Refuelling
Danger
Before refuelling, switch off
ignition and any external heaters
with combustion chambers.
Follow the operating and safety
instructions of the filling station
when refuelling.
Danger
Fuel is ...
Instrument Cluster Control
Adjusting Instrument Cluster Illumination
The instrument panel illumination intensity can be adjusted by pressing the control
switch with the headlight switch in any position when the ignition s ...
Copyright © www.kifomanual.com 2014-2025