1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Disconnect the connector from the motor.
[2 Door]
[4/5 Door]
|
3. |
Connect the motor terminals No.2 and No.3 directly to battery
voltage (12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General Power Window]
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Positive Crankcase Ventilation (PCV) Valve Operation Principle
...
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly.
...