Kia Forte: Component Location
| [Engine Room] |
| 1. Receiver Drier 2. Condenser 3. Ambient Temperature Sensor 4. Compressor 5. Discharge Hose |
6. Suction & Liquid Tube Assembly 7. Service Port (High Pressure) 8. Service Port (Low Pressure) 9. A/C Pressure Transducer (APT) 10. Expansion Valve |
| [Interior] |
| 1. Auto Defogging Sensor 2. Photo Sensor 3. Heater & A/C Controller (Manaul) 4. Heater & A/C Controller (DATC) |
5. Incar Sensor 6. Heater & Blower Unit 7. Evaporator Temperature Sensor 8. Cluster Ionizer |
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
...
Compressor Oil Specification
1.
The R-134a system requires synthetic compressor oil (PAG) whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
See also:
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Jump starting
Do not start with quick charger.
A vehicle with a discharged vehicle
battery can be started using jump
leads and the vehicle battery of
another vehicle.
Warning
Be extremely careful when starting
...
Front Hub / Knuckle Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
Copyright © www.kifomanual.com 2014-2025