Kia Forte: Blower Unit Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Unit Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
|
| 3. |
Seperate the blower unit from the heater unit after loosening
the screws.
|
| 4. |
Install in the reverse order of removal.
|
Blower Unit Components
1. Intake Seal
2. Intake Upper Case
3. Intake Actuator
4. Air Filter
5. Air Filter Cover
6. Intake Door Assembly
7. Intake Lower Case
8. NVH Pad
9. Blower Up ...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor voltage does not operate well, substitute
...
See also:
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...
CVVT (Continuously Variable Valve Timing) System Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated by the engine ...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the engine room under cover front panel (A).
3.
...
Copyright © www.kifomanual.com 2014-2024