Kia Optima Manuals

Kia Forte: Intake Actuator Inspection - Blower - Heating,Ventilation, Air Conditioning - Kia Forte TD 2014-2018 Service ManualKia Forte: Intake Actuator Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Intake Actuator Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the recirculation position when connecting 12V to terminal 3 and grounding terminal 7.

1. -
2. -
3. Fresh
4. Sensor (+ 5V)
5. Feedback
6. Sensor Ground
7. Recirculation

4.
Connect the intake actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminal 6 and 7.
Specification
Door position
 Voltage (V)
Error detecting
Fresh
 0.3 ± 0.15
 Low voltage : 0.1V or less
Recirculation
 4.7 ± 0.15
 High voltage : 4.9V or more

7.
If the intake actuator dones not operate well, substitute with a known-good intake actuator and check for proper operation.
8.
Replace the intake actuator if it is proved that there is a problem with it.
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake door by the signal from the control unit. Pressing the intake selection switch will shift between recirculation and ...

Intake Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body -"Glove Box Housing") ...

See also:

Cluster Fascia Panel Component Location
1. Cluster fascia panel ...

Rear Shock Absorber Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Door Switch Inspection
1. Remove the door switch and check for continuity between the terminals. ...

Categories

Copyright www.kifomanual.com 2014-2026