Kia Forte: Oil Pressure Switch Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Inspection
| 1. |
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the
fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 50 kPa (0.50 kgf/cm², 7.25 psi)
is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
|
Oil Pressure Switch Removal and Installation
1.
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
Tightening torque :
9.8 ~ 11.8N.m (1 ...
Oil Level Gauge & Pipe Removal and Installation
1.
Remove the oil level gauge (A).
2.
Install in the reverse order of removal.
...
See also:
Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing
fuse/relay name and capacity.
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable t ...
Fuel Tank Pressure Sensor (FTPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Cruise Control Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Mod ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026