Kia Forte: Battery Removal - Charging System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Battery Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / Battery Removal

1.
Disconnect the battery terminals (A).
(1)

2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Remove the battery insulation pad.
4.
Remove the battery (A) after removing the mounting bracket.

5.
Remove the ECM.
(Refer to Engine Control/Fuel System - “Engine Control Module (ECM)”)
6.
Remove the battery tray (A) after removing the bolts.

Battery Adjustment
Battery charging In general, vehicle battery charging system has three forms. 1. Constant current charge: The battery voltage gradually rises by charging w ...

Battery Installation
1. Install in the reverse order of removal. Battery (-)terminal installation: 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) ...

See also:

IMS Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Trunk Lid Weatherstrip  Replacement
(4Door, 2Door) 1. Remove the trunk lid weatherstrip (A).    ...

Front Washer Motor Removal
   - When servicing the washer pump, be careful not to damage the washer pump seal. ...

Copyright © www.kifomanual.com 2014-2024