Kia Forte: Crankshaft Position Sensor (CKPS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the crankshaft position sensor connector (A) and remove
the sensor after removing the installation bolt.
|
Crankshaft Position Sensor (CKPS) Inspection
1.
Check signal waveform of CKPS and CMPS using a scan tool.
Specification:
Refer to “Waveform”
...
Crankshaft Position Sensor (CKPS) Installation
•
Install the component with the specified torques.
•
...
See also:
Crash Pad Side Cover Component Location
[LH]
1. Crash pad side cover [LH]
[RH]
1. Crash pad side cover [RH]
...
Components
(4Door, 5Door)
1. Rear door inside handle cap
2. Rear door pull handle cap
3. Rear door trim
4. Rear door rear seal
5. Rear door panel
6. Rear door module
7. ...
Starter Installation
1.
Install in the reverse of removal.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026