Kia Forte: Release Residual Pressure in Fuel Line
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Release Residual Pressure in Fuel Line
There may be some residual pressure even after “Release Residual
Pressure in Fuel Line” work, so cover the hose connection with a shop
towel to prevent residual fuel from spilling out before disconnecting
any fuel connection.
|
| 1. |
Turn the ignition switch OFF and disconnect the battery (-) cable.
|
| 2. |
Remove the fuel pump fuse (A).
|
| 3. |
Connect the battery (-) cable.
|
| 4. |
Start the engine and let idle, and then turn the ignition switch
OFF after the engine has stopped on its own.
|
| 5. |
Disconnect the battery (-) cable, and then install the fuel pump
fuse.
|
| 6. |
Connect the battery (-) cable.
|
| 7. |
Delete the Diagnostic Trouble Code (DTC) related the fuel pump
fuse with the GDS.
|
Fuel Pressure Test
1.
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
...
Fuel Tank Removal
1.
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
...
See also:
On-vehicle Inpection
•
First of all, check for DTCs. If a DTC is present, perform
troubleshooting in accord ...
Rear Center Seat Belt Retractor Replacement
(4Door)
•
When installing the belt, make sure not to damage the
retractor ...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026