Kia Forte: Fuel Pump Motor Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Fuel Pump Motor Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Motor Removal

1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).

3.
Remove the head assembly (A) after releasing the cushion fixing clip (B).

4.
Disconnect the fuel tube quick-connectors (C).

5.
Remove the fuel sender (A) in the direction of an arrow.

6.
Disconnect the fuel tube connector (A).

7.
Remove the cut valve (A) after releasing hooks (B).

8.
Remove the reservior-cup (B) after releasing the fixing hooks (A).

9.
Release the fixing hooks, and then remove the pre-filter (A).
10.
Remove the electric motor pump motor (B) from the fuel filter (C) by pulling it in down direction.

Fuel Filter Installation
1. Install in the reverse order of removal. ...

Fuel Pump Motor Installation
1. Install in the reverse order of removal. ...

See also:

Front Lower Arm Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Air Ventilation Seat Unit Components Location
Components Location (1) 1. Seat back blower 2. Seat cushion blower 3. Air ventilation unit 4. Air ventilation switch Components Location (2) Components Locati ...

Copyright www.kifomanual.com 2014-2026