1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line".)
|
2. |
Turn the ignition switch OFF, and then remove battery (-) cable.
|
3. |
Remove the installation nut (B), and then disconnect the fuel
feed tude (A).
|
4. |
Disconnect the vapor hose (A) which is connected from the PCSV.
|
5. |
Lift the vehicle.
|
6. |
Remove the fuel tank.
(Refter to Fuel Delivery System - "Fuel Tank")
|
7. |
Remove the vapor tube and low fuel line fixing clip (A) by using
a common driver.
|
8. |
Remove the installation nuts, and then push the heat protector
in the direction of an arrow.
|
9. |
Remove the installation bolts (A), and then remove the fuel line
fixing clip (B).
|
10. |
Release the fuel & brake line protector (A) by disconnecting the
fixing clip.
|
11. |
Remove the fuel line.
|
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the resistance ...
Line Pressure Control Solenoid Valve Specifications
Direct control VFS[Line Pressure]
▷ Control type : Normal high type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current val ...
Component Location
1. EMS box assembly
(Engine control relay, Fuel pump relay,
Air conditioner compressor relay)
2. C/Fan 1 relay
3. C/Fan 2 relay
4. SSB 4(IG2) relay
5. Blower relay
...