Kia Optima Manuals

Kia Forte: Torque Converter Control Solenoid Valve (T/CON_VFS) Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Torque Converter Control Solenoid Valve (T/CON_VFS) Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Installation

1.
Install in the reverse order of removal.
  
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
•
Replace the gasket (A) before reinstalling the valve body cover.
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

26 Brake Control Solenoid Valve(26/B_VFS) Description
26 Brake(26/B) Control Solenoid Valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 Brake. ...

See also:

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Inspection
   • Frequent inhalation of brake pad dust, regardless of material composition, could be ...

Categories

Copyright www.kifomanual.com 2014-2026