1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to SS-A Solenoid Valve - "Specifications")
|
Fluid Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid (ATF) level is not normally
required during scheduled ...
Front Seat Belt Pretensioner Component Location
(4Door, 5Door)
1. Front seat belt pretensioner
...
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...