Kia Forte: Shift Cable Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Shift Cable Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable Removal

1.
Remove the floor console assembly.
(Refer to Body - "Floor Consol")
2.
Remove the air duct.
3.
Remove the shift cable (A).

4.
Remove the retainer (A) and nut (B).

Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

5.
Remove the nut (C) from the manual control lever.

Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

6.
Remove the cable (B) from the bracket (A) at transaxle assembly side.
7.
Remove the shift cable by pulling it toward the interior.

Shift Cable Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Cable Installation
1. Install in the reverse order of removal.    • ...

See also:

Rear Seat Latch Replacement
(4Door, 2Door)    • Put on gloves to protect your hands. ...

AGM Battery Installation
1. Install in the reverse order of removal.    When installing the battery, ...

Windshield washers (front)
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wip ...

Copyright www.kifomanual.com 2014-2026