1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the lighting switch of the multi-function switch.
(Refer to Multifunction Switch)
|
3. |
With the front fog lamp switch, make sure that continuity exists
between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
Front Fog Lamp
|
Rear Pillar Trim Replacement
(4Door)
•
Put on gloves to protect your hands.
...
Components
1. Timing chain cover
2. Inner roter
3. Outer roter
4. Oil pump cover
5. Relief plunger
6. Relief spring
7. Relief plug
8. O-ring (suction side)
9. O-ring (disch ...
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...