Kia Forte: Front Stabilizer Link Replacement - Front Suspension System - Suspension System - Kia Forte TD 2014-2018 Service ManualKia Forte: Front Stabilizer Link Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Front Suspension System / Front Stabilizer Link Replacement

1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

  
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
3.
Remove the stabilizer link (A) loosening the nut (B) and (C).

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Installation is the reverse of removal.
5.
Check the front alignment.
(Refer to Front Suspension System - "Front Alignment")
Front Stabilizer Bar Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. ...

Sub Frame Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

See also:

ETC (Electronic Throttle Control) System Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to ...

Component Location
Component Location (1) 1. Smart key unit 2. External buzzer 3. Door outside handle 4. Interior antenna 5. RF receiver Component Location (2) 1. Bump ...

Starter Removal
1. Disconnect the battery negative (-) cable. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &qu ...

Copyright www.kifomanual.com 2014-2026