Kia Forte: Front Strut Assembly Disassembly - Front Suspension System - Suspension System - Kia Forte TD 2014-2018 Service ManualKia Forte: Front Strut Assembly Disassembly

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Front Suspension System / Front Strut Assembly Disassembly

1.
Using the special tool (09546-26000), compress the coil spring (A).

Tightening torque:
58.3 ~ 73.5N.m (6.0 ~ 7.5kgf.m, 43.4 ~ 54.2lb-ft)

2.
Remove the self-locking nut (C) from the strut assembly (B).
3.
Remove the insulator, spring seat, coil spring and dust cover from the strut assembly.
4.
Reassembly is the reverse of the disassembly.
Front Strut Assembly Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Front Strut Assembly Inspection
1. Check the strut bearing for wear and damage. 2. Check the spring upper and lower seat for damage and deterioration. 3. ...

See also:

Fuel Tank Pressure Sensor (FTPS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Windshield washers (front)
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wip ...

Tail Gate Latch Component Location
(5Door) 1. Tail gate latch assembly ...

Copyright www.kifomanual.com 2014-2026