Kia Forte: Front Wiper Motor Installation - Windshield Wiper/Washer - Body Electrical System - Kia Forte TD 2014-2019 Service ManualKia Forte: Front Wiper Motor Installation

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Wiper Motor Installation

1.
Install the wiper motor.
2.
Install the crank arm.
  
To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkages exactly.
3.
Install the lower and upper linkage to the wiper motor crank arm.
  
To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkages exactly.
Be careful not to bend the linkage.
4.
Install the wiper motor and linkage assembly and then connect the wiper motor connector.

Tightening torque:
7 ~ 11 N.m (0.7 ~ 1.1, kgf.m, 5.0 ~ 7.9 lb-ft)

5.
Install the cowl top cover.
6.
Install the windshield wiper arm and blade.

Tightening torque:
22.5 ~ 26.4 N.m (2.3 ~ 2.7 kgf.m, 16.6 ~ 21.7 lb-ft)

  
-
The windshield wiper motor must be cycled to make sure that it is in the auto stop position.
If necessary, adjust the wiper arm and blade.
7.
Install the wiper arm and blade to the auto stop position.
A : Auto stop position (Blade)

Front Wiper Motor Removal
1. Loosen the windshield wiper arm nut (B) after removing a wiper cap (A). 2. Remove the windshield wiper arm and blade. ...

Front Wiper Motor Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 2. Attach the positive (+) lead from the battery to terminal ...

See also:

Height Adjust Replacement
(4Door, 5Door) 1. Remove the front seat belt upper anchor. (Refer to Front Seat Belt - "Front Seat Belt Pretensioner") 2. ...

Power Window Switch Circuit Diagram
Driver Power Window Switch [Driver/Passenger Safety] [Driver Auto Down] Passenger Power Window Switch Rear Power Window Switch ...

Component Location
[Engine Room] 1. Receiver Drier 2. Condenser 3. Ambient Temperature Sensor 4. Compressor 5. Discharge Hose 6. Suction & Liquid Tube Assembly 7. Servic ...

Copyright © www.kifomanual.com 2014-2019