Kia Forte: Head Lamp Aiming Instructions
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Head Lamp Aiming Instructions
The head lamps should be aimed with the proper beam-setting equipment,
and in accordance with the equipment manufacturer's instructions.
If there are any regulations pertinent to the aiming of head lamps
in the area where the vehicle is to be used, adjust so as to meet those
requirements.
|
Alternately turn the adjusting gear to adjust the head lamp aiming. If
beam-setting equipment is not available, proceed as follows:
| 1. |
Inflate the tires to the specified pressure and remove any loads
from the vehicle except the driver, spare tire, and tools.
|
| 2. |
The vehicle should be placed on a flat floor.
|
| 3. |
Draw vertical lines (Vertical lines passing through respective
head lamp centers) on the screen.
|
| 4. |
With the head lamp and battery in normal condition, aim the head
lamps so the brightest portion falls on the vertical lines.
A : Vertical(Low)
|
Front Fog Lamp Aiming
The front fog lamps should be aimed as the same manner of the head lamps
aiming.
With the front fog lamps and battery normal condition, aim the front fog
lamps by turning the adjusting screw (A) with a driver.
Head Lamp And Fog Lamp Aiming Point
| 1. |
Head Lamp (Low beam)
|
| 2. |
Turn the front fog lamp on without the driver aboard.
The cut-off line should be projected in the allowable range (shaded
region)
|
Head Lamps Installation
1.
Install the head lamp bulbs.
2.
Connect the connectors.
3.
Install the head lamp bolts (3EA).
...
Room Lamp Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the
room lamp connector (A).
...
See also:
Maintenance service
You should exercise the utmost care to prevent damage to your vehicle and injury
to yourself whenever performing any maintenance or inspection procedures.
Should you have any doubts concerning the i ...
Cluster Ionizer Description
The cluster ionizer helps clean odor in the vehicle or from the air-conditioner
system.
When the ignition switch is ON, the inoizer runs a "CLEAN" mode and then
a "ION" ...
Front Hub / Knuckle Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026