Kia Forte: Parking Assist Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System / Parking Assist Sensor Removal
[Front Bumper]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the ultrasonic sensor.
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
[Rear Bumper]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the ultrasonic sensor.
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
Parking Assist Sensor Installation
1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect t ...
See also:
Operation
Evaporative System Monitoring
Evaporative And ORVR Emission Control System
This system consists of a fill vent valve, fuel shut-off valve, fuel cut
valve (for roll over), two way val ...
Rear Door Trim Component Location
(4Door, 5Door)
1. Rear door trim
...
Timing Chain Installation
1.
Check that the TDC marks on the intake and exhaust CVVT sprockets
are slightly turned (about 2 to 3 teeth) from the TDC position after
the timing chain has been rem ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026