Kia Forte: Power Mosfet Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Power Mosfet Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after loosening the mounting screws.
|
| 3. |
Install in the reverse order of removal.
|
Power Mosfet Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
the blower motor.
3. ...
Blower Resistor Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
See also:
Telemetics Unit (TMU) Installation
1.
Install the MTS unit after connecting the cable and connector.
2.
Install the glove box housing.
3.
Connect ...
Rear Hub - Carrier Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from ...
Thermostat Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the thermostat gasket
Check the mounting ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026