Kia Optima Manuals

Kia Forte: Removal - Multifunction Switch - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Multifunction Switch / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
4.
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
5.
Disconnect the light switch connector (A) and the wiper switch connector (B).
6.
[RHD]Remove the wiper switch (A) by pushing the lock pin (B).
  
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

7.
Loosen the screws (2EA) from the multifunction switch assembly (A).
Inspection (With GDS)
1. Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. ...

Installation
1. Install the multifunction switch. 2. Install the clock spring. 3. Install the steering column upper and lowe ...

See also:

Front Impact Sensor (FIS)
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

Adjustment
Concentric Slave Cylinder Air Bleeding Procedure 1. After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the pl ...

Installation
1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...

Categories

Copyright www.kifomanual.com 2014-2026