Kia Forte: Seat Heater Switch Removal - Seat Electrical - Body Electrical System - Kia Forte TD 2014-2019 Service ManualKia Forte: Seat Heater Switch Removal

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Removal

Driver/Passenger Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the switch connectors (A).

4.
Remove the switchs (A) from the console upper cover.
[Driver]

[Passenger]

Second Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear door trim panel.
(Refer to Body - "Rear Door Trim")
3.
Disconnect the connector from the power window switch.

4.
Remove the power window switch (A) from the door trim after loosening the screws.

Seat Heater Switch Circuit Diagram
...

Seat Heater Switch Installation
Driver/Passenger Seat 1. Install the switchs and connect the switch connectors. 2. Insatll the floor console assembly. ...

See also:

Front Wheel Speed Sensor Removal
1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Specifications
Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 22.0 ~ 26.0 [20°C(68°F)] Fuel Ta ...

SRS Control Module (SRSCM)
The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The ...

Copyright © www.kifomanual.com 2014-2019