Kia Forte: Shift Cable Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable Removal

1.	Remove the floor console assembly. (Refer to Body - "Floor Consol")

2.	Remove the air duct.

3.	Remove the shift cable (A).

4.

Remove the retainer (A) and nut (B).

Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

5.

Remove the nut (C) from the manual control lever.

Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

6.	Remove the cable (B) from the bracket (A) at transaxle assembly side.

7.	Remove the shift cable by pulling it toward the interior.

Shift Cable Components

1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Cable Installation

1. Install in the reverse order of removal. â€¢ ...

See also:

Brake Booster Vacuum Pressure Sensor Description
In order to ensure adequate brake power assistance in every situation, the brake booster is equipped with a partial vacuum sensor. The brake booster vacuum pressure sensor is located beside t ...

Child restraint system
Children riding in the car should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. According to accident sta ...

Inspection
If any of the following conditions occur, WCS reset and accuracy check should be performed. â€¢ The WCS ECU or any of the sensors is replaced. â€¢ ...

Categories

Copyright © www.kifomanual.com 2014-2026