Kia Forte: SS-A Solenoid Valve(ON/OFF) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: SS-A Solenoid Valve(ON/OFF) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
(Refer to SS-A Solenoid Valve - "Specifications")
SS-A Solenoid Valve(ON/OFF) Circuit Diagram
...

SS-A Solenoid Valve(ON/OFF) Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

See also:

Front Driveshaft Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Engine Coolant Temperature Sensor (ECTS) Installation
   • Install the component with the specified torques. • ...

Checking the brake/clutch  fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch* ...

Copyright www.kifomanual.com 2014-2026