1. OAD (Overrunning Alternator Decoupler) pulley 2. Front housing 3. Front bearing 4. Stator 5. Rotor |
6. Rear bearing 7. Rear housing 8. Rectifier assembly 9. Regulator assembly 10. Rear cover |
Installation
1.
Install in the reverse order of removal.
2.
Adjust the ignition lock switch.
(1)
In state of full stro ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer to Body - & ...
Installation
1.
Install the boot (A).
2.
Install the clip to the clutch release fork.
3.
Apply to grease in location ...