[LEV2 Type] |
1. |
Lift the vehicle.
|
2. |
Disconnect the vapor hose quick-connector (A) and ventilation
hose (B).
|
3. |
Remove the protector installation bolts (C) and then remove the
canister.
|
1. |
Lift the vehicle.
|
2. |
Disconnect the ventilation hose (A) from fuel tank air filter
|
3. |
Remove the protector installation bolt (A) and nuts (B), and then
remove the canister assembly.
|
4. |
Disconnect the ventilation hose (A) and vapor hose (B).
|
5. |
Remove the auxiliary canister & bracket assembly (C) after removing
a bolts and nuts.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the vapor hose (A) and ventilation hose (B).
|
3. |
Remove the auxiliary canister (C) after removing the nuts (D).
|
Center Pillar Trim Component Location
(4Door, 5Door)
1. Center pillar lower trim
2. Center pillar upper trim
(2Door)
1. Rear inner outer trim
2. Center pillar upper ...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the vacuum pump connector (A).
...